can i use C-code - English Discussion Board

Assist Engineer
Rank: 1

UID 1339
Digest Posts 0
Credits 0
Posts 3
Reading Access 10
Registered 2009-1-2
Status Offline

Post at 2009-1-2 14:16 Profile P.M.

can i use C-code

Hi fnrds

I'm using parallel port to 20-pin Macraigor wiggler JTAG Debuger for ARM7TDMI-S LPC2129 Evaluation Board.
I dont have RDI Interface Driver in my KEIL, How to install it? where can i get it?
I wanted to know can i use my C-language code for debugging?

twentyone

Super Moderator
Rank: 8

UID 2
Digest Posts 1
Credits 0
Posts 2512
Reading Access 150
Registered 2008-2-15
Status Offline

Post at 2009-1-6 02:10 Profile Blog P.M.

If your KEIL installed in your PC don't have the RDI interface, change to the latest KEIL version. Several versions of KEIL don't have RDI interface. But the latest version comes with RDI interface again.

biradar.amit

Assist Engineer
Rank: 1

UID 1339
Digest Posts 0
Credits 0
Posts 3
Reading Access 10
Registered 2009-1-2
Status Offline

Post at 2009-12-28 19:29 Profile P.M.

Reply #2 twentyone's post

Thank you

I upgraded my Keil. I have another problem now.
I am using my own LPC2129 Evaluation Board along with Wiggler (same as Olimex dongle design). I could detect & reset the Target properly. When I start debugging in Keil, it gives following error

“RDI : System-Reset is not supported”.
No Algorithm found for : 00000000H – 000001d3H

I have assigned nTRST to PIN-6 (D4) & nSRST to PIN-2 (D0) where nSRST ouput is inverted in H-JTAG Server JTAG Settings. I am unable to locate the problem. Please assist me to download the program.

Thanking you

With regards
Amit Biradar


	Guest: Register \| Login \| FAQ